![]() If your BIOS is not up-to-date, you’ll have to install the last official Dell BIOS file the way it’s explained on the Dell support website and then follow the steps above. You can now refuse the confirmation message to update your BIOS, the temporary directory is automaticlly deleted You can now open the ROM file the way it’s explained on this very usefull web site Copy this file to a non temporary directory such as “c:\test” or whatever you want and change its extension to. dll file and the size of the file is 1024 KB or above But it’s easy to identify the ROM file : it’s neihter a. bin file but it could be something else). ![]() I can’t tell you exactly the file extension of the ROM file you need (in my case, it’s a. You will find a temporary directory containing the extracted files from the downloaded. Sort the content of this folder by date Browse the following directory : “C:\Users\Username\AppData\Local\Temp” where “Username” is your real Windows account name Set your Windows Explorer to show hidden and system files Don’t do anything else with this message at this time. exe BIOS, a confirmation message will pop-up Here is the only working way I’ve imagined and I’ve used. Don’t forget to mention the vendor and the name of your mainboard and the sort and version of the flashed PCI ROM module. Most important is a short report about the success or failure of flashing the “modded” BIOS into the BIOS chip of your mainboard. The data of their AHCI/IDE system will not be altered or destroyed by this procedure.Īny feedback is much appreciated. Then they can close the Utility and reset the SATA Controller to the usual setting (AHCI/IDE mode). ![]() After having temporarily enabled the “RAID” mode of the on-board SATA Controller they should run the RAID Configuration Utility and look, if everything seems to be fine (but don’t create a RAID array!). Users, who are running their SATA Controllers in AHCI or IDE mode, should check the function of the freshly updated RAID ROM module the same way. Everything will be fine, if you can enter and use the RAID Configuration Utility without any problem (Don’t modify anything, if you don’t want it to be changed!). If you have inserted a new RAID ROM version into the BIOS, you have to make sure, that the “RAID” mode of the on-board SATA Controller is enabled, and then you should run the RAID Configuration Utility by hitting CTRL+I, F10 or similar (look into your mainboard manual). Before you restart with your usual PC work, you should verify the full function of the updated PCI ROM module. ![]() If you have updated the Marvell 91xx AHCI/RAID ROM module, set the Marvell Firmware mode to “Force”, then save/apply/reboot and let it load through to windows, before that happens Marvell Firmware will update and board will reboot. Once in the BIOS again recover the previous boot settings (boot device and HDD boot order). Then turn on, boot to BIOS, load optimized, set the SATA Controller to the appropriate mode (AHCI/RAID) and save/apply/reboot back to the BIOS. Before you start with the BIOS modding procedure, you should have read carefully the “General Preparations for BIOS Modding” ( >Linkthisthishere<):Īfter flash is complete, shut down fully and switch off PSU, wait one minute and clear CMOS. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |